Search models, users, collections, and posts
Metal Roof Bolt Cover
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
8.7 h
2 plates
Open in Bambu Studio
Boost
11
24
2
0
21
20
Released
Description
This is a simple cap that can be used to cover the sheet metal roof protruding bolts.
Fill the cap with Sikaflex 740 or RTV Silicone this is recommended as it will stick to PETG, fill the cap with silicone then place on top of the bolt, using the silicone that comes out of the bottom of the cap to stick down the cap to the sheet metal.
Printed in PETG, no supports, default settings work no need to change anything. But 100% fill only adds a small additional amount of PETG
There are two plates either 1 piece or 100 pieces!
I HAVE NOT TESTED THIS CAP YET AND I CANNOT GUARANTEE THAT YOUR ROOF WONT STILL LEAK WATER THROUGH THE BOLTS.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)