BULLPADEL VERTEX 04

To achieve a perfect print of the BULLPADEL VERTEX 04 model. These settings have been tested on a Bambu Lab A1 mini with a 0.2 mm nozzle and 0.4mm should serve as an excellent guide for other printers

Recommended Settings for 0.2mm Nozzle

• Printer: Bambu Lab A1 mini
• Nozzle: 0.2 mm
• Print Profile: 0.10mm Standard @BBL A1M 0.2 nozzle
• Material: PLA

Quality and Layers

• Layer height: 0.1 mm
• First layer height: 0.1 mm
• Line width: 0.22 mm
• Wall generator: Arachne

Infill

• Infill density: 15%
• Infill pattern: Grid

Shell

• Wall loops: 3
• Solid top layers: 5
• Solid bottom layers: 5
• Top surface pattern: Monotonic

Print Speed

• First layer speed: 16 mm/s
• Outer wall speed: 120 mm/s
• Inner wall speed: 150 mm/s

Temperature

• Nozzle temperature: 220 °C (initial and subsequent)
• Bed temperature (Textured PEI Plate): 65 °C

Supports and Adhesion

• Supports: no supports
• Brim type: Outer brim only
• Brim width: 2.5 mm
• Skirt: Not needed

Recommended Settings for 0.4mm Nozzle

If you want to print this model with a 0.4 mm nozzle and achieve a high-quality result, here is a recommended configuration. These settings adapt the original profile to achieve a good balance between speed and detail

Size Recommendation

For a 0.4 mm nozzle, it is recommended to print the model at its original size or even scale it slightly upwards (e.g., 110%). Reducing the size might cause fine details to be lost

General Configuration

• Printer: Bambu Lab A1 mini (or similar)
• Nozzle: 0.4 mm
• Print Profile: E.g.: 0.20mm Standard @BBL A1M 0.4 nozzle
• Material: PLA

Quality and Layers

• Layer height: 0.2 mm (The standard for good quality with a 0.4 nozzle)
• First layer height: 0.24 mm (Slightly thicker to ensure good adhesion)
• Line width: 0.42 mm
• Wall generator: Arachne

Infill

• Infill density: 15% (Can be kept, it is a good balance)
• Infill pattern: Grid

Shell

• Wall loops: 3 (We keep 3 for good strength)
• Solid top layers: 4
• Solid bottom layers: 4
• Top surface pattern: Monotonic

Print Speed

• First layer speed: 30 mm/s
• Outer wall speed: 150 mm/s
• Inner wall speed: 200 mm/s

Temperature

• Nozzle temperature: 220 °C (Kept, it is a good value for PLA)
• Bed temperature (Textured PEI Plate): 65 °C

Supports and Adhesion

• Supports: no supports (enable_support: 0)
• Brim type: Outer brim only (Optional, may not be necessary with good first layer calibration)
• Brim width: 2.5 mm