DJI O4 lite case pavo 20

remix of several models

-https://makerworld.com/en/models/1347426-dji-o4-lite-case-pavo-20-pro?from=search#profileId-1389413 ----------- for the case

-https://makerworld.com/en/models/1130440-canopy-pavo-20-pro-dji-o4-without-insert?from=search#profileId-1132013 --------------------for the canopy

-https://makerworld.com/en/models/993381-pava-pico-o4-adapter-bracket?from=search#profileId-969313 for the o4 mount

I didn't do much, I just “glued” these three elements together to provide a DJI o4 lite mount for Pavo 20 pro with superior protection. I also added vents and increased the maximum and minimum tilt of the o4.

Thanks to the case from https://makerworld.com/en/@uppgrejdau The o4 is completely protected from all shocks and leaves all buttons and ports accessible. The creation from https://makerworld.com/en/models/993381-pava-pico-o4-adapter-bracket?from=search#profileId-969313 protects the camera's connector well in case of impact. It works perfectly on my pavo and gyroflow stabilization works perfectly. You will need M2 screws and M2 nuts to mount this canopy. It is possible to remove the plates on top of the canopy to slightly reduce weight. The plates are only there so that the top of your canopy is absolutely flat for your print bed pattern. If you have any questions feel free to ask!

I recently added a version for the wide angle from flywoo. I use the o4 pro version but the o3 version would also be compatible if you add two holes. Both versions work with M2 screws but I recommend adding M2 nuts to the designated holes for better retention.