Probes for Multimeter - Remix from Cadshef

This is a remix of the multimeter probes made by Cadshef, found on Thingiverse.

I had a few issues with their design, the slide mechanism that closes the plugs, were too short. The sleeve over the probe was too short, which in the end made it half open, and I did not want that.

In this design I did the following:
Plug = the part plugging into the multimeter
Probe = the part you hold in your hands while testing

- Extended closing mechanism on the plug
- Protective cover over the banana plug is longer
- Sleeve over the probe is longer, making it close better
- Hole for the wire is bigger, you can use wires up to 4mm total thickness

All in all I like this design way more than the original. I use quite a thick wire without a problem, my previous wires would constantly break.

Have you printed it and like it? Be sure to leave a nice review with a picture, thanks!