Parkside PBSPA 12 E4 driller magnetic bit holder
Print Profile(1)
Bill of Materials
- Magnets ⌀ 5x2mm x 5:
Description
This holder requires 5 rounded magnets (5×2 mm). In the project, I set a PAUSE command at the 40th layer (after about 15 minutes of printing). This is the moment to insert the magnets into the slots. If the magnets don’t stay in place, use superglue to secure them.
You can also print this model without magnets, but in that case the bits may fall out when the drill is turned upside down. Alternatively, you could resize the holes in any 3D editor, so the bits fit tightly in the slots.
Finally, remove the original plastic “BRUSHLESS” cover and replace it with the printed one.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)