Oktoberfest Decoration

WARNING: 
A 0.2mm nozzle is highly recommended for printing the flag. And you will need a possibility to print with five colours, too. Yes, this means two AMS or a H2D and one AMS.

O'zapft is! Welcome to the Oktoberfest!
 

While all the other Germans around me are getting drunk, I am still sitting here and designing strange stuff...
What better can match this time of the year than some Bavarian Oktoberfest Decoration for your mancave?

Print preparation:
Make sure that your print bed is clean and grease-free and use a quality brand and dry filament.

Print settings:
Use a 0.4mm nozzle with 0.2mm layer standard settings for the pole, the topper and the base. Pole and topper need support. 
For the flag a 0.2mm nozzle is highly recommended. The 0.12mm standard settings will do the job. You can try to print the flag with 0.4mm but this is not supported in my 3mf print profile. It WILL lack a lot of details.

This model is meant to be printed on Bambu printers with a minimum build space of 250mm and an AMS with five (!) colours. At the moment this is only possible with P1, X1 and H2 series printers.

Assembly: 
This is pretty much straight forward. 

• Remove all supports and brims thoroughly! De-burr and clean all parts.
• Rip the flag from the bed while it is still hot - then you can bend it in any way you like
• Slide the two pole halves together
• Push the pole into the hole in the base
• Slide the flag into the slot on the pole
• Push the topper on the pole

PS:
"Durscht wiad Sau" is Bavarian for "Thirsty like a beast".

If you want to support me you can leave a tip at ko-fi.com/blecheimer.

Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0. The shown model must not be used commercially.
Copying this model to other 3D printing websites is not allowed without my permission.