Triple Multi Filament Spool AMS

Hello Melter

Are you also tired of having spools with only ¼ or less filament left on them, but you need a full roll to start a large print For this, I designed this multi-filament spool holder for Bambu Lab spools

Simply insert the three segments into the Bambu spool, and you can wind 3 filaments onto one spool

so you have a few spools free again for larger projects

And if you only have small projects, you can rely on the multi-spool

An eyelet for threading the filament is attached to each of the 3 segments

Simply thread the filament, bend it slightly (see pictures), and you can spool the filament

I also designed spool clips that clip into the spool, so I don't have to reach inside the spool for filament clips

Simply clip the end of the filament at the top

The spool clips for the middle segment are included on the print plates

The spool clips for the Bambu spool are (AMS compatible) and can be found on MakerWorld model number:1796764

I also designed a two-slot spool holder Makerworld Model Number:1879978

Have fun melting

If you follow me, you can also see my over 65 other self-designed models.

I would be happy about a like, follow, and Boost.

Shopping cart release with chip

https://makerworld.com/en/models/1520308-shopping-cart-opener-and-chip

This is an accessory box for the P1S from Bambu Lab.

https://makerworld.com/en/models/2491029-p1s-toolbox

https://makerworld.com/en/models/1796764-spool-filament-clip-internal-ams-compatible

Have fun printing

your Uncle Peter