BK Precision 2709B Holder for Gridfinity

I'd like to start this one off with a big shout out to FollowSTep for helping test for fit the multimeter since I didn't have this one to try out and helping with the pictures. 

• The Basics 
  • It is a holder for the BK Precision 2709B 
  • 2 piece design with an upper and lower tray to hold everything.
• Features
  • Top
    • The pocket for the multimeter is designed to also accommodate the magnet on the back side as well as the velcro that holds it on at the top of the meter.  The pocket is also symmetric so the meter can be installed in either orientation depending.
    • The unit is 8u tall with a stacking lip as well so you can stack on top of it if need be.
    • There are 25mm finger pull notches cut in to be able to pull the unit out.
    • The base uses my preferred slide in for the magnet install, no glue needed.
    • Added a 2nd version that has an offset pocket and some extra storage at one end.
  • Bottom
    • 4u tall with stacking lip and slide in magnets.  Nothing to fancy, just a standard 4u bin from my base model.
• Print Notes
  • I split it up for a 2 tone print, feel free to print it single color if that isn't your jam, just change the 2nd part back to match the first. 
• Other Models available
  • DM6000AR Multimeter by AstroAI
  • Astro AI AM33D
  • Klein MM320

Feel free to browse my other gridfinity models. https://makerworld.com/en/collections/4365706-djr-engineering-gridfinity