Emperor Royal Guard * 500% * Star Wars

Emperor Royal Guard * 500% * Star Wars

Brick Figur ~21cm / 500%

Depending on the printer and filament you use, you may need to change some of the parts +/- 1%

The Picture what you see, was printed out on my Bambulab P1S Combo with AMS
with Bambulab Basic and/or Matte filament. (see part list below)

Join in and become part of the community on Patreon…

https://bit.ly/3KtMtRb 

The print need a AMS, but no glue to connect all parts.

Printer settings are done in the .3mf File attached

Settings for PLA i have done are:
Layer: 0,2mm // Support: Tree Support // Brim: depending on some parts, when you use A1

When you like my model, please give me a dump and and follow me. 

*******************************************************************************************

Important Note:

Some of the parts and accessories can be found by thall72's Printables profile.

Visite his site under ...
https://www.printables.com/@thall72/models

I hope you enjoy my creations. All figure creations are done by myself.