Search models, users, collections, and posts
P1P / P1S 5inch Screen Enclosure Mod
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
2.6 h
2 plates
Open in Bambu Studio
Boost
16
29
0
1
9
2
Released
Bill of Materials
List other parts
- Old USB A cable x 1:
- Solder Iron x 1:
- Heat Shrink & Heat Gun x 1:
- Electrical Tape x 1:
Description
This mod is for you if you are using the cable supplied with your screen. There are 4 wires and a connector with your screen. I used an old USB phone cable cut the USB A end off. Then soldered to the RED (+) and BLACK (-) wires of USB A end. Some USB cables run the negative with the shield no black wire.
Double check the board and plug for correct colors. They should say 5V or VCC and GND.
This allowed the USB cable to be feed to the back. (see pics)
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)