Modular Plamo / Gunpla / Model Kit Runner Holder

wanted to make a modular runner holder, i based it off of an old one i had which had the same grooves holding it up
parts are split into
- base holder ~50g
- extension ~13g
- label plate ~6g
the base holders hold 13 runners each

for small runners just printing the base holder is enough
larger runners i would recommend printing the extension as well since they have the same grooves at the end to hold them up
print the extension twice to have the letters clearly visible even with large runners
(the base holder is too short to hold big runners up on its own)

the included label plates are for doubled alphabet up to Z
although the 3mf file uses AMS, you can instead just set it to 1 filament, set a print pause on the layer and do a manual filament swap
the label plates can also be directly attached to the base runner instead if you want

ive also included a blank label plate if you want to emboss different labels on your own through bambu studio
emboss thickness is 2.5mm if you want it to be flush with the top layer