Search models, users, collections, and posts
Atlas Gunworks Holosun HS507COMP RMR Shim
IP Report
Print Profile(2)
0.08mm layer, 2 walls, 100% infill
Designer
15 min
1 plate
RMR Shim - Decrease Elevation
Designer
30 min
2 plates
Open in Bambu Studio
Boost
14
39
8
0
31
18
Released
Description
If you've got issues with your Holosun 507 Comp on an Atlas gun where you have run out of elevation and cannot move the red dot high enough, then this is going to be your solution. This shim goes between the RMR optic plate and your 507 Comp, with the thick side towards the front. I designed this because I didn't want to spend $11 on one from Amazon when I have a 3D printer at home.
The shim is roughly a .975° shim, with the thin side being .288 mm thick, and the thick side being .984 mm thick. This raises the front of the 507 Comp enough to where you will have more leeway with your elevation adjustment.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)