Snubbull-like humanoid brick figure
Print Profile(1)
Description
Boost Me (for free)
The editable version of the file is open source, I hope you can support me a lot, thank you
It is recommended to print with PLA, PETG printing may cause shrinkage issues leading to mismatched parts. It is recommended to wear gloves during assembly, and some parts require strong finger pressure. If some printed parts have holes that are not large enough or are too large, you can appropriately enlarge the holes or use 502 glue to bond them. For movable parts, you can apply 502 glue and then twist the parts after waiting for it to dry a bit to solve loosening issues
The parts are small, if the build plate is not sticky enough, remember to spray adhesive
This model's parts can be swapped with the Brooky Ultraman series
Some parts may still be optimized, if you have any issues, please raise them in the comments
The STP file format has been uploaded, I hope that after experts modify the design, they will also open source it and share it with everyone
When removing supports, pay attention to the chest armor area, there are two posts, be careful not to damage them
Also, the forearm area is print in place, it is rotatable, you need to twist the part
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (9)