Landing Gear for DJI Mavic 3 V1.1

🎯 The model is designed for use by Ukrainian drone operators

🛠️ Attention: I am working remotely at the request of the military, this model has not yet been tested in real flight. If you have the opportunity to install and test it on a drone, please leave your feedback in the comments or write to me personally. This will greatly help with further improvements

⚠️REGARDING THE QUESTION OF WHY I MAKE SOME OF MY MODELS FREELY AVAILABLE

The orcs have all of this and also know how to model, on my page there are only models that do not pose a direct threat to life, the points collected in Maker World go towards purchasing plastic and printers for me and the military, I hope the question is closed

These 3D-printed clip-on legs are specially designed for the DJI Mavic 3 drone to increase its ground clearance to approximately 15 cm. This provides additional space underneath the drone where any extra equipment can be attached

The legs easily clip onto the drone's body using clips that precisely match its shape and hold securely. If necessary, they can be further secured with zip ties

💡 Tip 1: if 15 cm of ground clearance is too much for you, you can shorten the legs in the slicer (Bambu Studio, OrcaSlicer, PrusaSlicer, etc.) – simply trim the model's height to the desired level before printing. The design allows this without loss of functionality

⚠️ Tip 2: pay attention to the flow rate in the slicer. In many, it is set too low by default (e.g., 0.94), which can make the clips brittle.
It is recommended to set the flow rate to 1.0 to ensure strength