Derpy Tiger KPop Demon Hunters Wall Decor

Disclaimer / License

This model is for personal use only.
Commercial use is not allowed.

You may not sell, redistribute, or use this model or any printed versions of it for profit without my explicit permission.
If you are interested in selling the printed version of this model you will have to purchase my Commercial License on Patreon: 
https://www.patreon.com/Fabria3D/membership ($10 membership gives you the right to sell all past, current or future models on my MW page while valid)

Derpy and Sussie Line Art

This is a line art model featuring Derpy and Sussie.

• Uses about 55g of filament at the default size.
• Can be scaled down to fit an A1 mini or scaled up for larger printers.
• Make it as thick or thin as you want. I don't recommend going thinner than 3 mm but it can save some filament. Or go thicker if you want it to stand up straight on it's own.
• Important: Wait until the print bed is fully cooled before removing the model to avoid breaking it.

TIPS:

• Wash your build plate with hot water and soap.
• Use Arachne Wall Generator to best preserve quality.
• I have placed 10 brim ears on points with a lot of stress, you can turn them off by going to Other > Brim Type > No-Brim, but they are very easy to remove and help wtih adhesion.
• Bump up your bed plate temperature by 5 degrees.
• Use Avoid Crossing Wall setting at 200-300 mm to have less stringing.
• If your have a P1/X1/H2 series printer, consider turning off Aux Fan, otherwise the part the aux fan is on might warp!