Trophy with Crown
Remixed by
Boost
2
1
2
Print Profile(0)
Add the first print profile to earn points
Boost
2
1
2
0
17
0
Released
Comment & Rating (2)
All
FYI- you have 13 non-manifold edges at the top of the base, right where the spiral starts- which are not in the original model. I printed the original model successfully without getting that warning. Might want to look into it.
The designer has replied
0
Reply
Hi, I will check :) thx!
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (2)
Related Models
© 2024 MakerWorld