Heat gun holder (Quick 959d+)

After seeing the vertical heat gun of Quick 861DW, I've always wanted to change my own holder to a vertical one
One reason is its high aesthetic appeal, and the other is that the air pump's tube takes up too much space when directly hung on the earpiece. A vertical stand can save some space, and a storage slot for the soldering iron stand is reserved, further saving space

As for whether the hot air will melt the soldering iron, after printing the model, I found that only half of the heat gun has a magnetic induction device, so the heat gun holder needs to be placed on the same side as the earpiece to prevent the heat gun from not going into sleep mode. The area directly blown by the heat gun has been hollowed out, and testing shows it will not damage the holder

10mm*2mm magnets need to be installed on the holder, it is recommended to fix them with hot glue because the holes are 12mm in diameter

The upper and lower parts are fixed with M3 screws, but can also be fixed with hot glue (