Search models, users, collections, and posts
USMC Birthday - Tun Tavern Mug
IP Report
Print Profile(2)
Magnet holes, 0.1mm layer, 2 walls, 7% infill
Designer
2.8 h
1 plate
No Magnets - 0.1mm layer, 2 walls, 7% infill
Designer
6.3 h
2 plates
Open in Bambu Studio
Boost
13
24
6
0
16
10
Released
Description
This design was done with the 250th birthday of the Marine Corps in mind. It is a mug from the 1700s with Tun Tavern and the date the Marine Corps was founded. I made a version with 6x2 magnet holes on the back and a version without the magnet holes. The size of the mug is approximately 146x143.
The models have been corrected to fix a couple of typos. The magnet hole size was also decreased slightly to provide a better fit without requiring any glue. In testing, I was able to fit two mugs on the print bed with only minor defects on the surface that would end up being the back, but I couldn't include that in the print profile since it was rejected by MakerWorld.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)