Nat20 Headphone Holder

Hello, Nerds!

What could level up your computer or gaming setup better than a d20 for your headphones?

This simple wall-mounted holder lets you add some flair, and the included brackets make it easy to install with two small Command Strips or screws.  I found my clumsiness can knock it a little bit with the straight-sided bracket, so I made a version with an angled bracket for a little more stability if you want/need it.

There are FOUR included versions:

• Straight Bracket Supported Version: For those of us who can't be bothered to do post-processing and want a clean d20 surface finish right off the printer.
• Straight Bracket Support-Free Version: Saves a bit of filament, provided your printer can bridge ~34mm easily.
• Angled Bracket Supported Version: For those of us who can't be bothered to do post-processing and want a clean surface finish right off the printer.
• Angled Bracket d20 Support-Free Version: Bit more stability and saves a bit of filament, provided your printer can bridge ~34mm easily. Note, the bracket piece still requires support, unfortunately, because of the geometry.

The front d20 piece friction-fits nicely onto the holder arm without glue, but a dab of glue is recommended if you're clumsy (like me) or just want extra security.

If you'd like a stand or desk-mount version, let me know! I have some ideas, but my setup needed a wall mount first — so that's where I started.

Happy printing, and happy gaming!

(Legacy design, reuploaded from prior profile.)

💖 Bytes & Brushstrokes