Strap adjuster generator

Strap ajduster generator.

With the strap adjuster generator, you are able to make the adjuster according to your own needs! Change the thickness, amount of slots, len/width of slots, borders and corners!

I've printed my strap adjuster with PLA because that's what I had available, but I do believe PETG would be a sturdier choice.

Parameters:

• Slot amount: Amount of slots to generate.
  • Through this parameter, it is possible to create a single- or double slot adjuster (or more).
• Slot space: The amount of space between each slot in mm, if there is more than 1 generated slot.
• Slot width: Width of slot in mm. 
• Slot length: length of slot in mm.
  • Add 2-4mm + strap width to this parameter - to ensure the fit is not too tight.
    • For example, for a 30mm strap, I would put in 32-34mm for the slot length.
• Slot corner radius: The corner radius of a slot in mm.
  • Set value to 0 for straight corners.
     
• Border top and bottom: The border which extends outward on the top and bottom in mm.
• Border left and right: The border which extends outward on the left and right in mm.
• Border radius: The border corner radius in mm.
  • Set value to 0 for straight corners.
     
• Adjuster thickness: The thickness of the entire strap adjuster.