8*8 ws2812 Colored Light

A colorful lamp made from an idle 8*8 SW2812 light board. I bought a controller from PDD. Direct remote control is sufficient

The main components used are an 8*8 SW2812 light board, a lithium battery, a charging board, an SW2812 controller, and a switch

The total cost, making good use of coupons, is around 20 yuan. The controller is mainly a bit expensive. But it was also bought for 10 yuan

The light guide post needs to be printed with a 0.1 layer height. Anyway, everyone knows how to print transparent parts

Alternatively, you can buy 5mm thick acrylic light guide rods. The length can be arbitrary. The effect will be better

Regarding custom settings:

You can set the height of the light guide post. The default is 70mm. If you want it longer, just change this parameter

The base part of the light guide post. The setting is 1mm. If using acrylic or glass light guide strips, you can modify this parameter to raise the connection height between the base and the light guide post, increasing stability

I also designed a cover plate, which can be multi-color, to cover unsmooth or unsightly surfaces after support removal. Use this to address the issue. Just stick this on directly. The default height is 1mm

How the above data is combined is entirely up to personal preference

A little glue is needed for bonding