Filament runout sensor
Print Profile(2)
Description
Filament runout sensor that can be used with printers without a built-in one. Utilizes an inexpensive micro switch.
There are two versions included:
- Filament runout sensor without legs, intended to be used independently, installed somewhere before the hot end
- Filament runout sensor with legs, intended to be used with Top Runout Mount
Additional parts needed:
- Piece of 4mm OD 2mm ID PTFT Tubing
- Micro switch with a roller
- Thin electrical wiring
Small screws, 2 pcs
Assembly instructions:
Cut a piece of PTFT tube to length and add a cutout according to the picture
- Solder the electrical wires to the switch and thread them through the opening in the base
Put the PTFE tube and the switch into the base
Fasten the lid using two screws
If you like the design, consider buying me a coffee or contact me for a custom design inquiry at:
https://buymeacoffee.com/tinkerer_designs
Check out my portfolio:
https://makerworld.com/en/@tinkererdesigns
Boost Me (for free)
Do you want to see more designs like this?
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)