Certain A2SPro assembly TPU printed parts

        To accommodate various capacitors, two versions of the antenna capacitor base have been designed: one for 6.4mm capacitor diameter and one for 10mm capacitor diameter. Players can choose to print based on their needs.

        The model is primarily designed to eliminate the jello effect from the o4lite, so it fully secures the capacitor, pigtail antenna, and buzzer. Tested under full throttle, there's no jello or vibration at all. The rear also has a power cord exit to manage the power lines neatly;

        The lens cover perfectly fits the Pocket 2 wide-angle lens, and the default angle is very low, around 10 degrees. For a wider angle, simply adjust it upwards; there is no upper limit to the maximum angle;

        The installation positions for the side protection brackets support the default 6mm shock absorber posts + o4lite shock absorber posts. After tightening the nuts on both sides, the side guards will be taut, providing effective protection;

        All mounting accessories are M2*14mm*3mm copper pillars, and the model uses a 9*5.5mm 5V buzzer