Montezuma's revenge (PC version) Level 1

As a young boy I loved playing Montezuma's revent on my old IBM PC with 4 color CGA screen (now you know how old am I). I was looking for a 3D picture of this game over the internet but could not find one - so i made one. Not sure about the color scheme i originally played so i just just worked acording to a picture i found on line. This is actually more than a 4 color scheme, otherwise it would have turned out pretty dull for printing in my eyes…. 

This model is scaled up to an A4 board size and is designed to fit an A4 size frame which is more than 7 mm deep (if you wish to close it with glass). I bought a frame  but allthough it was marketed as A4, the effective work surface was smaller - so i just printed a customized fram with the help of this model : https://makerworld.com/en/models/1363251-customizable-wooden-picture-frame?from=search#profileId-1434208 by @pitchblackcat :) the right size frame is in the 3mf . 

in addition, i have added an A4 size backplate i have designed. I strongly reccomend to stick a piece of black A4 sheet to the plate to cover the seems as it is printed in 4 part so i could fit a Bambu X1C bed  

the print is pretty straight farward and i have tried to slice it in a way to reduce time consmuming multi color prints, so most of the part required either one of two color replacments at specific height. anyway i have inclued the original screen picture for referance. 
 

Please note:  
1. Some parts need supports and i have also used anti warp disk for the frame parts - FYI

2. There are two versions of the DOOR model. The short one - is the original size as per the ref picture. the Long one is the same model extended by 7 mm, so to take up a full A4 sheet height (in landscape) because i messed up when modeling the screen in fusion and measured the ref picture 7 mm too short…. 

special parts: 
The webs, rope, flames and conveyor - have tiny parts that are either barly touching eachother or completly disconnected - so for those parts i have added a 1 layer black surface to hold everything together while glueing it to place. This is done with an additional cube part in the 3mf and IS NOT part of the model - so if you think of a better way to print them - be my guest.