Search models, users, collections, and posts
NAFO Fella's! - Say NO to Russia - Slava Ukraini
IP Report
This model is created by Image to Keychain
Make Your Model
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.5 h
1 plate
Open in Bambu Studio
Boost
19
12
2
1
3
0
Released
Description
Best is to run 0.4 nozzle, 0.2 layer height or even variable layer height
0.2 with 0.16 initial layer height
print relatively slow:
initial layer 30mm/s with 90mm/s initial infill
Outer wall: 185-200
Sparce infill: 200
Solid Infill: 180
Top layer: 150 (this is extremely important to get a smooth top/back finish)
10% Gyroid infill
No supports
Maybe a brim if worried about adhesion
Let the BONKING begin!
Boost Me (for free)
Boosts are always awesome and extremely appreciated! It helps me keep up the motivation and will to keep going and find weird fun stuff to plop on the internet. Lets have some fun while we have the chance!
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (2)