2x4 Tee Jig Hanger, Easy slide + remove w/ holder - Free 3D Print Model

Search models, users, collections, and posts

Good Mayhem Racing

Tools>Hand Tools

IP Report

GIF

Print Profile(1)

All

H2S

X1 Carbon

H2D

X1E

P1P

H2D Pro

P1S

A1 mini

0.2mm layer, 2 walls, 0% infill, ASA, no supports smooth pei

Designer

2.2 h

1 plate

Open in Bambu Studio

Boost

112

Released

Bill of Materials

Bambu Filaments

Select all

Gray (45102) / Filament with spool / 1kg

ASA

List other parts

60x10x2mm magnets x 2: not needed, but good for holding screws. Glue magnets in place. hotglue or super glue are fine.

Description

Handyman tool to help place 2x4's in rafters, attic spaces, crawl spaces and more. 3rd hand tool that easily clips onto a 2x4 one handed and easily slides off. Designed by engineer. No Supports, no infill! Infill free. Support Free. Prints fast with very high quality. Fill your build plate for diy fun for everyone! Great handyman gift. Start off with two.

Use one on either end of a 2x4 for jig a span jig. Make out of ASA, PETG, Polycarbonate or other ductile materials. Recommend higher temp materials for use in hot attics. PLA is a bad idea for these.

No Supports, no infill! Infill free. Support Free. Prints fast with very high quality. Fill your build plate for diy fun for everyone!

Add 60x10x2mm magnets to hold screws. Line up the 2x4 fast with easy view between clips. Glue magnets in place, but magnets are not required for use. Square up after screwing one end in place.