Search models, users, collections, and posts
Spray bottle cap compatible with DSPIAE airbrushes, compatible with cheap pointed-tip bottles (with compatible Tamiya paint mixing bottle interface) DSPIAE
IP Report
Print Profile(3)
0.2mm layer, 2 walls, 4% infill
Designer
5.8 h
8 plates
0.08mm layer, 2 walls, 15% infill
Designer
12.9 h
8 plates
0.08mm layer, 2 walls, 15% infill
Designer
12.9 h
8 plates
Open in Bambu Studio
Boost
77
158
11
3
151
72
Released
Description
Content has been automatically translated.
Requires a soft tube with an inner diameter of 4mm and an outer diameter of 6mm. If paint cannot flow smoothly, use a TPU printing washer (placed under the needle; printing with other materials should also work, but I haven't tried it). You can also cut a small section of the soft tube to act as a washer, compatible with common dispensing needles.
If there is air leakage or the needle cannot be installed after printing, you can check the dimensional compensation or if the material is stringing. If it still doesn't work, a 0.2 nozzle is recommended for printing.
The original specifications are compatible with cheap plastic pointed-tip sub-bottles from Pinduoduo
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (11)