Sasani

cover

Judy-web.png

Judy_02_4x3.png

judy-bead.gif

plate_1.png

2025-09-15_365ef7a01bf938.png

Size:<ul><li>~12mm³ for the bead</li><li>The hole is 2.5mm (actually 2.51 for extra wiggle room)</li></ul>Filament used:<ul><li>.59g</li><li>infill can be changed lower than 10%, but it will become easier to squish</li></ul>Print time:<ul><li>18m25s</li><li>This is due to the slower printing speed to increase quality.</li><li>I think it&#39;s better to have a higher quality print over speed.</li></ul>Settings:<ul><li>Line width is smaller than usual, but works with a 4mm nozzle.</li><li>0.12mm layer height to increase smoothness of the print.</li><li>Arachne wall generator.</li><li>10% line infill. This was a good balance of strength and filament usage.</li><li>Outer wall speed lowered—particularly good for silk to get a good shine.</li><li>Acceleration speeds are lower to ensure a quality print.</li><li>Brim is disabled, but for some printers it might be necessary to enable.</li></ul>&nbsp;Although multiple beads can be printed at the same time, it is advised to print a test bead first.

0.12mm layer, 2 walls, 10% infill

Judy is a bit wobbly looking, but she&#39;s a good bead. This is a high quality print and the bead is made to be fairly sturdy. It can be used for braiding, making friendship bracelets, crochet, knitting, macrame, kumihimo, etc. The bead as about 12x12mm. The hole is 2.5mm (though it is actually 2.51mm for extra wiggle room if needed).&nbsp;I do recommend keeping the printing settings with lower layer height and slower printing speed—it helps in making this bead look cool.&nbsp;I&#39;ve printed it from Bambu Basic PLA and the gold silk shown in the images. The ripples on it make even Basic PLA interesting with the way light interacts with it.&nbsp;Multicolor, gradient, silk, transparent, glow-in-the-dark—anything would be interesting.

A Bead Named Judy

ASIA

Print Profile(1)

Description

Comment & Rating (1)

License

Related Models