Angle Corrector for Insta360 Go (1, 2, 3)

If you own an Insta360 Go, Go 2, or Go 3, you're likely familiar with the problem: when using the magnetic pendant, your footage inevitably points upwards, following the line of your chest. While newer versions like the "Go Ultra" have addressed this flaw, older models were left without an official solution. Until now.

I designed this angle corrector to fix this exact issue, finally ensuring you get perfect POV (Point Of View) shots. The design not only corrects the vertical tilt but also allows you to precisely aim the camera by rotating it. For maximum versatility, I have created three distinct versions.

• Tilt Versions:

  

  • 10 degrees: A slight correction for minor adjustments.
  • 15 degrees: The most balanced angle, perfect for everyday use.
  • 20 degrees: The maximum tilt for sports or when a significantly lower shot is required.
  •  
• Printing and Assembly Instructions:
  • CRITICAL Layer Height: To ensure the joint works smoothly and doesn't break, you must print with a layer height of 0.12mm or less.
  • Supports: Very few supports are needed, strategically placed to ensure a clean final model.
  • Assembly: Before inserting the pendant, make sure to fully open its lace.
  • Secure Fit: The pendant locks into the frame extremely securely. Removing it might be a bit difficult, but that's the small price to pay for the peace of mind that your action cam won't move an inch during the action!

Download the version that suits you best and bring new life to your Insta360 Go footage! Join my community to stay updated on future versions of this and other accessories! I'm working on new solutions, including fully magnetic and non-snap-fit versions.