Star Wars Datapad Phone Case, Pixel 9 / 9pro Remix

I was looking for a fun phone case for my Pixel 9 Pro for my trip to Star Wars: Galaxy's Edge at Disneyland, and found this neat design by HP_Larpcraft.

Remix Changes:

• Decreased the overall size and modified it to fit my Pixel 9 Pro (it should also fit the Pixel 9)
• Smoothed down a few of the pointy bits
• Added a few more points for fasteners to hold it together
• Redesigned the “wheel” on the front to be a lower profile “slider”

Notes:

• This worked great for me for a couple of long days of fun in Disneyland, but I don't know if I'd trust it for extended use. It's just a fun little cosplay case for getting into the spirit of Galaxy's Edge.
• If your eyes didn't already tell you, this is not cushy ergo case :)  That said, it was more comfortable to hold than I expected, considering all of the sharp edges.
• The case is a very snug fit, and when printed with PLA it'll flex enough for a good tight fit after securing the screws.

• My included print profile is configured for using a support interface filament (ie: Support for PLA/PETG)

  *If you use support interface filament, a bit of a flex of the finished print should loosen the support enough to remove*

• I have a Caseology Tempered Glass screen protector on my phone and the front of the case fit around the perimeter of that protector just fine, but YMMV if you've got a different screen protector installed. 
• Printed in Bambu Lab PLA Metal in Iridium Gold Metallic and Iron Gray Metallic
• Fastened Together with the following bolts
  • 4- M4 x 8mm Countersunk Hex Socket Head
  • 3- M3 x 8 mm Countersunk Hex Socket Head
  • 1- M4 x 8mm Flat hex Socket Head (you can use another countersunk hex socket head instead)
• Painted with water-based permanent acrylic markers, then dry brushed to weather it with a mix of brown and black acrylic paint

If you dig my remix, please post a pic of your finished print. It's fun to see other makes!