Search models, users, collections, and posts
Overall Tensegrity Structure Suspension Ornament
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
6
14
1
0
36
21
Released
Description
Content has been automatically translated.
This is an overall tensegrity structure model that gives you the illusion that it is suspended
Please tie the ropes yourself (no special requirements for wire diameter, just not too thick) Long ropes are recommended to be 10~15cm, short ropes 5~7cm
When assembling, please try to ensure that the long ropes maintain a consistent length, which helps the ornament to be placed more stably and beautifully
Please slowly adjust the length of the ropes; it is recommended that you mark the ropes beforehand before tying them
Reserved holes make it easier to thread thin lines
If it droops like this, please tighten the short ropes
Please place the more hollow cantilever on top and the base at the bottom; the ornament cannot be inverted stably, please use it correctly
This model is prohibited for commercial use without the author's permission
Produced by Anmao
Boost Me (for free)
Thank you for your support; I will put more effort into creating more interesting models
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)