Search models, users, collections, and posts
Leviton Structured Media Fiber Optic Loop corner
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
33
171
9
8
119
65
Released
Description
This fiber optic loop holder was designed to work with Leviton structured media cabinets and their pins. The fusion 360 file is included so you can more easily modify/remix it. Some improvements I might suggest are adding more constraint for the fiber optic loop and/or zip ties.
There are many orientations this loop holder can be fixed in using two pins. Because you're only printing 60 degrees of the loop with each one you can
While its designed for fiber optics this would likely work just fine with other cabling. Keep in mind the bend radius modeled is 50mm (~2in) and could not fit a single cable jacket bigger than 16mm (~0.63") nicely.
Prints fine on an A1 Mini with overhangs unsupported with Bambu PLA Matte
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (9)