Arccos Sensor Adapter for Super Stroke (VERY SLIM)

I tried other versions of this adapter and was disappointed as they all were bigger than the original adapter offered by Super Stroke.  I deciced to make my own and try to get it as small as the original.  I ended up getting it even smaller than the original (after way more test prints than I care to admit).  Anyways, pretty self explanatory, remove the screw from the grip, place the screw into the bottom housing, put the washer in between the grip and the bottom housing, screw it in, insert arcoss sensor, put cap on.  

Be sure to use my print settings if at all possible, most important part is to print it in .08 layer height.  No supports needed.