Milky (without AMS)

Update from 05.12.2025:

Since some had difficulties with the eyelashes, there is now a new print profile for the eyelashes and a tool.

This allows the eyelashes to be printed flat and bent over the tool with the help of a hairdryer.

I have attached detailed instructions.

I built Milky from Milky & Schoki chocolate bars for you.

Milky is about 14 cm tall and fits perfectly with my Schoki, which you can find here

I used transparent PLA for the glass rim.

The model is divided into 8 print plates, but you don't need all plates. Depending on your printing project, you can omit some plates

Here is the description for the print plates and their necessity:

For printing without AMS you need:

Plate 1: Shoes and mouth

Plate 2: Eyes and eyelashes

Plate 3: Legs and dowels for attaching the legs to the body

Plate 4: NOT

Plate 5: Milky body without glass rim (without AMS)

Plate 6: Glass rim for gluing (without AMS)

Plate 7: Base plate for Milky, otherwise it will fall over. This plate is for Milky alone

alternatively

Plate 8: Base plate for Milky and Schoki (if you want both on one plate)

For printing with AMS you need:

Plate 1: Shoes and mouth

Plate 2: Eyes and eyelashes

Plate 3: Legs and dowels for attaching the legs to the body

Plate 4: Milky body and glass rim (with AMS/filament change) 

Plate 5: NOT

Plate 6: NOT

Plate 7: Base plate for Milky, otherwise it will fall over. This plate is for Milky alone

alternatively

Plate 8: Base plate for Milky and Schoki (if you want both on one plate)

When removing the eyelashes from the supports, I recommend being very careful and possibly using a knife as an aid, as they are very delicate. However, it worked very well for me.

The eyelashes are only glued on.

The eyes are plugged in. Please note that the left eye has a short plug and the right eye has a long plug. The small bevel on the plugs should be facing downwards for both eyes.

For the legs, the shoes only fit on the correct leg; please follow the specified orientation on the print plate.

The legs should be attached to the body with the dowels and glue.

The shoes should be attached to the legs and the base plate with glue.

Check out my other model as well:

 Milky & Schoki Winter Edition

I hope you like my model, then feel free to leave a boost and a rating.