Action Figure Risers - 1:12 GI Joe Classified

This easy to assemble/disassemble riser set can hold nine 1:12 action figures. It's not fancy but it does the job. Be sure to print the wall plate twice so that you have 4 pieces for optimal support. 

I've printed it in PLA as well as PETG with good results. 

Assembly: 
 There are grooves in the underside of the platforms which allow the walls to be inserted. It is a snug fit. 

 There are lap joints in the bottom of the walls which allow the lateral supports to snap into place. 

 I'd recommend starting with the left wall and the top platform, working across thru all walls. Then the middle platform followed by the bottom. Then install the back lateral support followed by the front.