Toyota Rav4 adapter silicone wiper fluid funnel

This is a custom lid for the Toyota RAV4 XA30 wiper fluid reservoir. The stock opening on the RAV4 is larger than the common Skoda-style funnel lids you see on AliExpress, so I remodeled the cap to fit the RAV4 opening and extended it to work as an adapter for the foldable silicone funnel.
 

Instructions

The model is designed with print-in-place supports that must be removed after printing. Do not enable slicer supports, as only the built-in ones are needed. Once the print is finished, make a small slit along the long thin wall.

Then you can easily remove the support.

The support side up is where you connect the funnel and the other side should clip-in n the reservoir hose,  it should press into place smoothly.

Notes:

• May fit other Toyota models with the same hose.
• The one I bought is not listed anymore but any listing like this should work fine

Printing:

• I have printed with Bambulab PETG-HF
• Infill: 10% Gyroid
• Line width: 0.42 (Is the thickness of the support wall)
• Layer height: 0.28
• Walls printing order: Outer/Inner