Search models, users, collections, and posts
MT07 Slider/Crash Pad
Remixed by
IP Report
Print Profile(1)
0.24mm layer, 4 walls, 90% infill
Designer
7.3 h
1 plate
Open in Bambu Studio
Boost
32
84
3
0
46
17
Released
Description
Crash pads stick out 5,5cm to the side, this is just enough to protect most of the plastics and the engine if you accidentally “lay down” your bike.
Apply 2 layers of electrical tape so the pads are connected very sturdy into your frame (see pictures), without the tape they WILL fall out, you could also use double sided tape, just try out what works best for you and it should be connected pretty tight.
Twist and use a rubber hammer to insert the pads into the frame very tightly.
This is my first ever own designed 3D-Model so feel free to give me any advice!
- Print profile is ready to go and set up for PETG.
(USE AT OWN RISK, I CAN'T GUARANTEE THEY WILL FULLY PROTECT YOUR BIKE OR THAT THEY WILL NEVER FALL OUT!)
This remix is based on
The model does not exist anymoreLicense
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)