Search models, users, collections, and posts
Bulbasaur Clicker - Flat Top Bulb Edit
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
21 min
1 plate
Open in Bambu Studio
Boost
13
39
2
3
76
63
Released
Description
This is a flat-topped version of the Bulbasaur clicker model made to alleviate some possible print issues in the original.
The model can be printed without a Brim if desired, just be sure to clean that print bed. Tested in PETG as it was the filament I had on hand.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)