Search models, users, collections, and posts
Bambu X1C/P1S Rear Exhaust Vent/Duct (50mm/2in)
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
4.3 h
1 plate
0.2mm layer, 3 walls, 25% infill squishy
52 min
1 plate
Open in Bambu Studio
Boost
68
195
9
1
141
88
Released
Description
Rear vent for Bambu printers, designed for use with 50mm or 2 inch ID ducting. Outlet is designed vertical with an offset to allow for clearance and accessibility for printers that are butted against a wall or window. Pipe bead allows for secure hose attachment, with or without clamps.
Utilizes the existing holes on the Bambu casing for mounting; no magnets required. Refer to this guide to tap the chamber vent holes:
https://wiki.bambulab.com/en/knowledge-sharing/exhaust-pipe-connector-installation-tutorial
Compatibility with AMS Hub is unconfirmed.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (9)