Search models, users, collections, and posts
EKTORP Sofa Leg with Base
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 35% infill
Designer
20.2 h
2 plates
Open in Bambu Studio
Boost
11
26
3
0
26
6
Released
Description
This is a remix of the EKTORP Leg that was posted many moons ago; my EKTORP sofa had a sudden collapse on the rear corner (likely due to one too many moves over the last 8+ years). As such the wooden corner piece was gone, so after finding the EXTORP Leg STL, I added the bottom corner piece and inserted holes for screws (rather than the staples that IKEA used originally).
I printed in PLA Matte (Bambu Lab) on P1S with 35% Infill (Cubic), 6 walls, and extremely sturdy.
Such as the original designer of the leg stated, I'm pretty positive this part will far exceed the life of the couch
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)