Anti-splash cover BambuLab X1 P1

Anti-splash cover BambuLab X1 P1

Boost
273
596
133

Print Profile(5)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

2024-2-29 Dual version color separation settings
2024-2-29 Dual version color separation settings
Designer
1.6 h
3 plates
4.9(36)

2024-2-17 Remove 1.5mm of side baffle
2024-2-17 Remove 1.5mm of side baffle
Designer
31 min
1 plate
5.0(18)

PETG -1,5mm _ 0.2mm layer, 3 walls, 25% infill
PETG -1,5mm _ 0.2mm layer, 3 walls, 25% infill
26 min
1 plate
4.9(15)

PLA - 0.2mm layer, 3 walls, 40% infill
PLA - 0.2mm layer, 3 walls, 40% infill
21 min
1 plate
4.7(23)
Click to see more

Boost
273
596
133
6
1.1 k
557
Released

Description

*Please do not use PLA printing. When replacing materials, heat will be absorbed by the metal piece on the waste port, causing heat accumulation. There is a possibility that the consumables will be softened and deformed or stuck and unable to fall out. Recommended high temperature resistant materials such as ABS/ CF or GF

 

This accessory has a certain blocking effect. Because the variables are too large, I cannot ensure that it can 100% prevent large particles of poop from splashing out. To me it's half decorative.😊

 

 

Comment & Rating (133)

Please fill in your opinion
(0/5000)

Print Profile
PETG -1,5mm _ 0.2mm layer, 3 walls, 25% infill
prints fine
The designer has replied
2
Reply
thanks
(Edited)
2
Reply
Boosted
Print Profile
PETG -1,5mm _ 0.2mm layer, 3 walls, 25% infill
Had problems with poop flying around the bed before adding this into my Bambu P1S but afterwards no issues whatsoever. Thanks for designing this!
The designer has replied
1
Reply
thanks
(Edited)
1
Reply
Perhaps the prettiest cover I've ever printed, I used a blue-gray PETG trim and a black PC body
1
Reply
Print Profile
2024-2-17 Remove 1.5mm of side baffle
perfect
(Edited)
1
Reply
Print Profile
2024-2-29 Dual version color separation settings
Thank you for the clearance adjustments. Never had stuck filament again. Printed in ASA with 0.5% increased scaling to account for shrinkage.
1
Reply
Print Profile
PLA - 0.2mm layer, 3 walls, 40% infill
quick and easy print. first snug
1
Reply
The print profile is no longer public
Good
1
Reply
The print profile is no longer public
Perfect Fit on P1S, Prusament PETG Black Matte. Printprofile as by designer.
1
Reply
The print profile is no longer public
nice
1
Reply
The print profile is no longer public
So far 5 stars, will adjust if they dont work out
1
Reply