Cake Pop Holder - Free 3D Print Model

Search models, users, collections, and posts

robdean08

3D Printer>3D Printer Parts

IP Report

Print Profile(4)

All

P1S

H2S

H2C

H2D Pro

X1 Carbon

X1E

H2D

P2S

P1P

X2D

A2L

A1 mini

0.2mm layer, 3 walls, 10% infill

Designer

3.2 h

1 plate

4.8(8)

0.2mm layer, 2 walls, 15% infill

Designer

3.1 h

1 plate

5.0(2)

A1-Mini size with Bottom

Designer

2.4 h

1 plate

0.2mm layer, 2 walls, 15% infill Bottom added to the holder

Designer

3 h

1 plate

Open in Bambu Studio

Boost

285

374

250

Released

Description

Needed a Cake Pop holder for an upcoming event

4mm holes spaced out 30mm apart

43 holes in total

Comment & Rating (16)

@user_1305337543

Boosted

can you make this a bit smaller for an A1 Mini?

The designer has replied

@robdean08

I have added an A1-mini profile

@user_3310615061

A version where the holes at the bottom are closed would also be good. So that you can carry the part from A to B sometimes. I have now taped tape to the bottom so that the rods do not slip through. The holes themselves fit well

The designer has replied

Show original

@robdean08

I have added a profile with a bottom on the file

@user_991695181

Print Profile

0.2mm layer, 3 walls, 10% infill

Exactly what I needed. Nice clean print. I scaled up to 110% because I read others had problems with the sticks not wanting to go in. Is brilliant.

@user_411049903

Hello, do you think it's possible to have one with a bottom but for oval popsicle sticks please <3

Show original

@user_2181660768

Print Profile

0.2mm layer, 3 walls, 10% infill

estupendo

@user_3310615061

Print Profile

0.2mm layer, 2 walls, 15% infill

Fresh off the printer! The details on this model are insane!

@newmike13

Print Profile

0.2mm layer, 2 walls, 15% infill

This is a great cake pop mold and tray.

@pparadise

Holes were too small for the sticks I was using. This was a last-minute print and I didn't have time to address by drilling and/or reprinting, so kind of a bust for me.

@GWDesigns

Print Profile

0.2mm layer, 3 walls, 10% infill

This works pretty well, though I did have to make the holes a little bigger with drills because they didn’t quite fit the width of the cake pop stick I was using.

@UncleParker

Print Profile

0.2mm layer, 3 walls, 10% infill

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.