Vaporeon Chibi

VAPOREON CHIBI IS HERE

Less and less remains to finish the **Eeveelutions** series Many of you asked for **Vaporeon** I hope it meets your expectations 

As always I am providing a multi-part version to print without **AMS** and a colored one-piece version for **AMS** Over the next few days I will upload both the version for A1 mini and the uncolored one-piece version

ASSEMBLY:

The assembly actually has no great mystery I recommend fitting the back piece it's a press fit you might find it a bit difficult but it must go all the way in then we continue with the neck part followed by the two head pieces the ear pieces should be glued there are small indentations to fit them in so it shouldn't give you much trouble 

THE EYES: I personally found that it might be harder than usual to fit these pupils I had to resize the eyes at the last minute so the pupils only have one way to fit try fitting it before gluing it I found it helpful once it was in place to press it against a flat surface until most of the pupil clicked into place

the nose should be the easiest to fit in the entire series

as always do not hesitate to let me know your problems I will do everything I can to help

NOTICE: I have noticed that when printing the head piece for some reason it does not fully print the entire piece so a slight unevenness can be seen compared to the upper head piece this should not happen in the model these pieces fit perfectly however I don't see it as a very noticeable problem obviously I will fix it but give me time it is still almost imperceptible 

MEW CHIBI IS NOW AVAILABLE: https://makerworld.com/es/models/2001608-mew-chibi#profileId-2155245

If you want to sell physical prints of my designs, you can get a commercial license on Patreon.
You can also support me there so I can keep creating and uploading new models: www.patreon.com/cw/Atseini 💙