Kitchen scale holder without screws

Very useful. I had to resize it to fit my scale. Thanks!

Perfect Bambu Lab P1S, Sunlu PLA

fits perfectly, finally a place for the scale

Works well for me. I think we’re using the same scale. Printed with white SUNLU PLA on my A1. Sturdy enough. I used double-sided tape for the other end without hooks. Unfortunately, my board is 1 mm wider than yours, so the hooks bend a bit. I might even cut them off completely and just use double-sided tape instead.

I had a hard time getting the correct size for my shelf...then when I did the back sagged so much it required double-sided sticky tape (Alien tape works great). I cut off the shelf brackets and used the tape to secure the brackets. I think this is a bit easier/simpler/saves more filament and you don't have to worry about cans toppling on the shelf bracket support. I added a backstop to the back for the channel to prevent the scale from sliding too far into the slot. Great concept and very useful.

In itself a good idea - unfortunately our kitchen scale is 18mm high. A shame

I had a problem with adhesion on one side of the bed but reprinted in different orientation and looks fine. Nice model

unfortunately did not fit my scales. but good print.

The tablet holder was made because the wage got too thick, now it's under the living room table

so simple and yet useful