Search models, users, collections, and posts
bmcu microswitch model
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 20% infill
Designer
26 min
1 plate
Open in Bambu Studio
Boost
1
1
0
0
1
0
Released
Description
Content has been automatically translated.
bmcu entrance microswitch holder, optimized as a single part. When installing, tilt the microswitch and gently press it in. A 2mm hole is reserved on the side; if the gap is too large, you can use filament or a 2mm pin to secure it. This single part makes installation much easier compared to separate components. Supports are required for printing.
Documentation (2)
Assembly Guide (2)
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)