Search models, users, collections, and posts
BetaFPV Air65 Low Angle Camera Clip
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
9 min
1 plate
Open in Bambu Studio
Boost
157
365
21
2
385
137
Released
Description
A simple extending clip that fits with the original canopy to lower the camera angle.
It only requires one extra small screw, which is the same or similar to the one used to hold the canopy itself.
NOTE: The clip has a thicker end with a smaller hole for the top side so the screw thread can attach to.
It works well printed with any material.
Tested with Air65, probably works on similar canopy designs.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (21)