Cable tidy hole cover

Supports left some very rough residues, probably due to a too small support area width. But other than that, print works fine!

I only adjusted the measurements to my needs

the printing is perfect but the model could be improved, the cap is just placed, a clip system would have been better because with the slightest movement of the cables it can move from the base. for the rest nothing to report 😉👍

could do with being round 5mm larger for a uk plug but other than that very good quality.

what size hole is this for?

very but I had to adjust the diameter of the clip so that it fits well and clips correctly

I printed it upside down to save some filament, but I'm not sure if it was because my filament had a bit of moisture, but the top part of the circle turned out a little rough, but I think it was my fault, anyway it turned out excellent for my desk

Tolles Design

Great model, I scaled it to the size i needed and works perfect!