45W Asus laptop charger cable hook/coil

My new asus laptop came with a 45W charger, but i wanted to easily store the cable, so I came up with this. You put the cable through the hole, slide the print over the charger and roll your cable around the two hooks, make sure the little hook preinstalled on the cable is on the end, you will use that to secure the cable to already wound cable so the cable stays wound.

Print without support (it's already included), 4-6 walls, 20% infill.

Tip: When rolling leave a bit of slack at the beginning of the cable, to prevent damage.

This will fit your charger as long as its 53x28mm.