Search models, users, collections, and posts
Bang Dream Membership Card Protector Case
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
24 min
1 plate
Open in Bambu Studio
Boost
0
2
0
0
2
1
Released
Description
Content has been automatically translated.
Designed according to the thickness of fan-made products (membership card slot depth 4mm). If any Bang Dream fan has an official membership card, please help verify it. Thank you very much.
The NFC backplate is optional. You can use it by soldering an NFC chip, which seems to cost only a few cents.
Board link:
(It uses the same coil as the Arknights pass holder I released before. The former works fine currently. The streamer can't test the new board at home /(ㄒoㄒ)/~~)
The fixing screws are m3. If you don't need the NFC backplate, m3*10 should be fine. For the NFC backplate, buy m3*12. Remember the corresponding nuts().
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (0)