Search models, users, collections, and posts
Honeywell C7189U1005 Indoor Remote Sensor COVER
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
29 min
1 plate
Open in Bambu Studio
Boost
2
4
0
0
16
6
Released
Description
🧩 Honeywell C7189U1005 Remote Sensor Cover (Replacement Cap)
✨ Design Highlights
- Designed for the Honeywell C7189U1005 Remote Indoor Temperature Sensor, commonly paired with Honeywell smart thermostats.
- My home came with this setup, but the sensor cover was missing — rather than buying a whole new unit, I modeled this simple slide-on replacement cap.
- Includes vent holes to maintain accurate temperature readings while keeping the electronics protected.
- Clean, low-profile look that blends nicely with the wall and original Honeywell design.
🖨️ Print Details
- Material: PLA, PETG or ASA if you really wanted to
- Layer height: 0.2 mm
- Infill: 10–20%
- Supports: None needed
- Orientation: Print base-down
💡 Notes
- It’s a simple snap-on cap, so tolerances are forgiving — no tight fit required.
- Great little fix if your sensor cover went missing or cracked.
Original Honeywell product link for reference:
- No affiliation — just a handy print to save you from buying a whole new sensor.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)